FPV-drone GEPRC CineLog35 V2 Analog

GEPRC CineLog35 V2 Analog is a 3.5-inch FPV drone for hobby, training, sports flights, and video shooting. The model is built on the GEP-CL35 V2 frame with a propeller guard design and can be used indoors or outdoors, provided safe flight conditions are followed.

The drone is equipped with a GEP F722-45A AIO V2 flight controller, SPEEDX2 2105.5 motors, HQ DT90 propellers, a Caddx Ratel2 analog camera, a GEPRC Peano 5.8 RHCP UFL antenna, and an XT60E1-M power connector. Actual flight characteristics depend on the battery, settings, weight of additional equipment, flight style, and conditions of use.

Features

• GEP-CL35 V2 frame with a 142 mm motor-to-motor distance.
• Protective structure around the propellers for use in cinewhoop builds of the corresponding format.
• GEP F722-45A AIO V2 flight controller.
• SPEEDX2 2105.5 motors and HQ DT90 propellers.
• Caddx Ratel2 analog camera for transmitting a video signal in a compatible FPV system.
• GEPRC Peano 5.8 RHCP UFL antenna.
• XT60E1-M power connector.
• Battery mount with strap and 7075 aluminum elements.
• 3.5-inch format is suitable for compatible FPV builds with a protective frame.
• Approximate flight time: from 5 minutes to 8 minutes 30 seconds according to the manufacturer. Actual time depends on the battery, weight, flight style, and conditions of use.

Compatibility
Before use, it is necessary to check the drone’s compatibility with the battery, charger, controller, receiver, FPV goggles or monitor, frequency settings, and firmware of the specific configuration.

Version changes:
May 8, 2023: the motor in the CineLog35 V2 was changed from SPEEDX2 2105.5-2150KV 6S to SPEEDX2 2105.5-2650KV 6S.
September 4, 2023: the GEP-M8U GPS in the CineLog35 V2 was changed to GEP-M10 GPS.

CLI for CineLog35 V2: https://geprc.com/downloads/cinelog35-v2/

Package contents
1 x CineLog35 V2 Analog
2 x HQProp D-T90MM propellers (2 pairs)
2 x Battery straps M20*250 mm
2 x Silicone battery pads
1 x Screw set
1 x L-shaped hex screwdriver 1.5 mm
1 x L-shaped hex screwdriver 2 mm
1 x L-shaped hex screwdriver 3 mm
1 x M5 wrench
1 x Plastic tweezers
1 x Antenna fixing tube (pair)
1 x Keychain
1 x GP camera mounting base
1 x Naked GP mounting base
1 x Antenna mounting base

Screw set includes
2 x Screws with spacers M2*18
2 x Flat head screws with washer M2*5.5
1 x Flat head screw M2*12
2 x M2 screw-nuts
4 x Flat head screws M2*8
4 x Flat head screws M2*7
4 x Flat head screws M2*6
2 x Flat head screws M2.5*6
2 x Hex screws M1.6*8
1 x M5 flange nut
2 x Brass insert nuts M2*1.9-OD4.9
2 x Iron nuts M2
2 x Iron nuts M2
2 x Rubber dampers for camera mounting