Battery Charger BETAFPV 6 Ports 1S Battery Charger

This charger for 1S batteries has 6 ports and supports PH2.0 and BT2.0 connectors. The device is designed for charging compatible 1S batteries used in FPV drones, whoops, and other radio-controlled equipment.

Features
• Two types of BT2.0/PH2.0 ports allow charging compatible 1S batteries with the corresponding connectors.
• PD3.0/QC3.0/BC1.2 charging protocols are supported. The charging current of each port can reach 1A when using a compatible power adapter.
• The charger can be used at home, at the workplace, or during trips for flying.
• For correct operation, a compatible USB-C power adapter with the appropriate parameters must be used.

Fast Charging Support
When using a compatible 30 W power adapter, the charger supports PD3.0/QC3.0/BC1.2 protocols. The maximum charging current of one port is up to 1A. According to the manufacturer, 6 BT2.0 batteries with a capacity of 300 mAh can be charged in approximately 25 minutes, but the actual time depends on the capacity, battery condition, number of connected batteries, and power adapter parameters.

If a power adapter with less than 30 W output or an adapter without fast charging support is used, the charging time may increase. When charging six batteries simultaneously, each port may not reach the maximum current of 1A.

Button Functions
The button is used to switch the charging voltage. Available value: 4.35V.

In new batches, the switch on the left changes the "4.2V" mode to "OFF". This is shown in the image above.

Package Contents
1 6-port charger for 1S batteries. 
1 user manual.